CM2MTK 1.25 : Тянем книжку из звонилок и смартов на MTK

[yurii-62]

Сообщение от JayDi

.
В 1.30 сегодняшнем исправил. Нужно будет потестировать.

Не захотел пока..

Operation : Read UserData [ v1.30 ]

PhoneBook : Enabled
1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey

Wait for phone...
Phone found! [ 86 ]
Sync...
Inital regs read done
Boot Info : 
BB_CPU_ID : 6595
BB_CPU_HW : CB00
BB_CPU_SW : 8A00
BB_CPU_SB : 0001
BB_CPU_NM : [MediaTek] MT6595_S00
Processing BROM stage
BLVersion : 0xFE
SecCfgVal : 0x00000000
BromVersion : 0x05
BLVersion : 0xFE
Preloader Status : Not active (Erased)
Processing DA stage
DA Select done , sending 
DA Ver : MTK_AllInOne_DA_v7.1533.03
NAND_ID : 00000000000000000000000000000000
eMMC_ID : 150100425742433352023648B0329113
DA Stat : v3.2 on BBID : 0x8C
DRAM not initialized , configure DRAM Settings
DRAM EmiReq Ok , 0x00B0
DRAM Init Ok , 0x40000000
DA Sent. Configure setting now ... 
DA started successuflly
eMMC FlashIC initialized
[eMMC] : FLASH_VEN : 0015 , OEM : 0100
[eMMC] : FLASH_INF : R3CBW
[eMMC] : FLASH_CID : 150100425742433352023648B0329113
[eMMC] : FLASH_EXT : 00400000/00400000
[eMMC] : FLASH_LEN : 0x0000000747C00000
INT RAM    : 0x00020000
EXT RAM    : 0x80000000
BOOT TYPE  : EMMC_FLASH_BOOT
SOC VERIFY : C1
Boot Ok!


USBDL : Init HSUSB Ok
Step #1
Error while reading PhoneBook! Code : 0x02 :(

Operation Failed
Elapsed: 00:00:29
Reconnect Power/Cable!