Обновления RIFFbox JTAG

[yurii-62]

27.03.2012

RIFF JTAG – Samsung SCH-I500 Galaxy S Mesmerize/Fascinate Unbrick Supported
Repairing bricked Samsung SCH-I500 Galaxy S Mesmerize/Fascinate is easy with RIFF Box.
I500 is based on the S5PCxxx Processor (ARM core is Cortex-A8). Please note the adaptive clocking mode (RTCK) is not available on this processor, so make sure to select a fixed TCK frequency.
To establish the JTAG connection attach battery cable and press Power On key.
In case after resurrection the download mode is not initiated (LCD remains blank) do repeat resurrection with ‘Clone Gremlin zone’ option checked.
To resurrect Samsung I500:
Solder JTAG cable to Samsung I500 JTAG pads;
Attach battery cable and press Power On key;
Make sure Samsung I500 is selected in the list of models;
Make sure a fixed TCK frequency is selected;
Click Resurrect button;
Wait till software signals a successful operation completion;
Disconnect USB cable, de-solder JTAG wires;
Now phone is in bootable condition, that is, even if it does not start up normally, you can flash it using original Samsung downloader software to restore it to the working state.
.

Статья:
http://www.jtagbox.com/jtag-news/rif...rick-supported

[yurii-62]

31.03.2012

RIFF JTAG – Samsung SCH-i920 Omnia II 8GB Unbrick – Dead Boot repair supported

Repairing bricked Samsung I920 AP (PDA Part) is easy with RIFF Box. Due to some hardware pecularities, we recommend to use only battery without USB cable connected. Please note, during connection establishment phase you will have to press the Power On key twice.
To resurrect Samsung I920 AP:
Solder JTAG cable to Samsung I920 AP JTAG pads;
Make sure Samsung I920 AP is selected in the list of models;
Insert battery; make sure no USB cable or charger is connected;
Press the Power On key;
Click Resurrect button;
When it stops at “Establish communication with the phone…” press the Power On key again;
Wait till software signals a successful operation completion;
Disconnect USB cable, de-solder JTAG wires;
To resurrect Samsung I920 CP:
Solder JTAG cable to Samsung I920 CP JTAG pads;
Make sure Samsung I920 CP is selected in the list of models;
Insert battery and connect USB cable or charger;
Wait till AP part boots up completely;
Click Resurrect button;
Wait till software signals a successful operation completion;
Disconnect USB cable, de-solder JTAG wires;
Now phone is in bootable condition, that is, even if it does not start up normally, you can flash it using known flashing methods.
.

Источник:
http://www.jtagbox.com/jtag-news/rif...pair-supported