Z610 Setool и c UFS ом проблема

[gsi]

Z610 с УФС ом прошивается но не включается.
Setool ом прошиваю на настройку ставляю галку Complete phone after flash, unlock after flash, use server, enable alternative security bypass после этого вот лог
v0.914023/UNI
CARD SERIAL: 000
Loaded 51 flash descriptors
Connecting to UFS...
Found 2 FTDI device(s).
UFS #00000 READY
SERVER SUPPORT ENABLED.
ALTERNATIVE SECURITY BYPASS ENABLED.
ChipID:9900,EMP protocol:0301
Speed:921600
OTP LOCKED:1 CID:51 PAF:1 IMEI:35283601942149 CERT:N/A
FLASH CID:52 COLOR:RED
PATCH:061205 1523 HANCXC9876543210_DB2020_MEM_PATCHER_R2A006 0
LDR:061201 1314 HANCXC1329129_DB2020_FLASHLOADER_R2A005
Flash ID check:2019
Flash props sent ok

CID52 BYPASS PROCEDURE STARTED
Processing part1...
Processing part2...
Processing part3....
OTP LOCKED:1 CID:51 PAF:1 IMEI:35283601942149 CERT:N/A
FLASH CID:52 COLOR:RED
PATCH:061205 1523 HANCXC9876543210_DB2020_MEM_PATCHER_R2A006 0
LDR:061201 1314 HANCXC1329129_DB2020_FLASHLOADER_R2A005
Flash ID check:2019
Flash props sent ok

RESTARTING PHONE,IF PHONE NOT RESTARTS,THEN
REMOVE BATTERY FROM PHONE AND INSERT IT BACK

CID52 BYPASS PROCEDURE FINISHED

bypassing security...
ChipID:9900,EMP protocol:0301
Speed:921600
Trying to launch embedded bootloader...

потом на внизу пишет Press STOP if process not continue in 15 seconds.

Помогите пожалуйста!