|
скачал обновление Infinity но в нём ещё нет поддержки
COM3 selected
Device: Autodetect
Checking data, wait...
advanced flash detection active
Action: read/check detailed information
Boot...
Press and HOLD Power button now !
baud autodetection active
19200
Connecting, wait...
Initializing[6226:8A02:8A01]...
high speed disabled
boot step size: 0002
Release Power button now !
Boot Done
Initialize...
detecting chip #00 in region #00...
flash: 89880F00010001:89880F00000000
flash: Intel Intel/Sharp ext [def 0004x008000 007Fx020000] 16Mb
number of flash chip/regions detected: 01/01
Initialize Done
Set baud...
460800
Set baud Done
Check space...
device parameters autodetection in progress..
detecting chip #00 in region #00...
flash: 89880F00010001:89880F00000000
flash: Intel Intel/Sharp ext [def 0004x008000 007Fx020000] 16Mb
number of flash chip/regions detected: 01/01
total flash region size: 01000000
detect device identification, method #1...
detection phase #1...
detect device parameters finished
structure: 2nd [enhanced] (or higher) generation
identification data Ok
identification data backup saved: id.BFFA5ED2.[MY6226_PCB01_GPRS_MT6226_S01.DM200_V009_1_3_MATRIX .BIN_557D5F33].rpl
identification detection finished
device-id: BFFA5ED2
protocol ver: 04
ver. sw1: MY6226_PCB01_GPRS_MT6226_S01.DM200_V009_1_3_MATRIX .BIN
ver. sw2: DM200.V009.1.3.matrix
ffs offset/size: 00F00000/00100000
detecting eeprom area in 1 chip(s)...
flash: 89880F00010001:89880F00000000
checking area[00000000]: 00000000-00FFFFFF...
eeprom found near: 00F00000
Detected eeprom address is non-standard: 00F00000
If you are not sure that detected address is correct:
1. press "NO" right now
2. make flash backup for emergency case
3. repeat required operation
Are you sure that detected eeprom address is correct ?
Do you want to use standard eeprom address[00E00000] ?
standard eeprom address confirmed by user
detecting eeprom size...
eeprom size: 00200000
eeprom chip: 00
eeprom area detected[00000000]: 00E00000-00FFFFFF
detection phase #3...
.................................................. ..............
done
detecting structure pass 1...
...............
detect standard location pass #1...
.................................................. ......
detect extended location pass #1...
..................................................
detect standard offset pass #1...
detect standard data...
layout detection complete
eeprom element #1 detected ok
file saved: backup_system_log_BFFA5ED2_MY6226_PCB01_GPRS_MT622 6_S01.DM200_V009_1_3_MATRIX.BIN_557D5F33_20070730-095547.B0X.bin
Finished, time used: 124 sec
Remove/Install battery now !
|