Показать сообщение отдельно
Старый 02.12.2012, 17:10   #1
yurii-62
Супермодератор
 
Аватар для yurii-62
 
Регистрация: 28.03.2009
Адрес: Ставрополь
Сообщений: 2,000
Поблагодарил: 2,044
Поблагодарили 2,607 раз за 1,093 сообщений
Репа: 2317
Цитата:
2. Your cable is not TX2 Enabled!
3. Transmission error occured, try again
In either cases, you need to reconnect your box from USB
Цитата:
FlashChip 0x00EC2400 (Samsung), Size: 64MBytes, VPP: 9V
RAP3Gv3_algo.fg, Type: Algorithm, Rev: 0.10.40.0, Algo: BB5 ALGORITHM
Flashbus Write baud set to 2.0Mbits
Transmission Mode Requested: Dual Line, 32 bit, Accepted: Dual Line, 32 bit
Box TX2 Data Pin set to: Service Pin 3
Box VPP disabled
Internal CMT Phone VPP Enabled
Цитата:
Storing Simlock...
Trying to store WMDRM RPL...
Reading Keys...
Storing WMDRM PD...
Reading Security Block...
Security block OK and saved to "RM-495_352700045099842_30.11.2012_171102.SecurityBloc k.PM"
WARNING: "192002117FD34950B8A59709FED7C8CD1762B1CE.C00045B2 " Not Exists, Will read it...
Reading CYC file from phone...
Цитата:
Readed OK, Saving to "192002117FD34950B8A59709FED7C8CD1762B1CE.C00045B2 "
Storing Additional Data...
Checking Superdongle Key...
Encrypting Superdongle Key...
Storing Superdongle Key...
Checking CMLA Key...
CMLA Key Store Problem -> Failed to decode Security Section, Box Reported: Security Section Not Found (SL3 phone?)
Booting CMT...
Цитата:
Using OLD BB5 FLASHING PROTOCOL
If software STUCK HERE with box TX LED lit, that means:
1. You have not attached yellow TX2 Adapter (IT IS REQUIRED FOR BB5 PHONES WHEN USING JAF/UFS CABLES!)
2. Your cable is not TX2 Enabled!
3. Transmission error occured, try again
In either cases, you need to reconnect your box from USB.
На лог циклона не обращали внимание? для начала выполните условие что просит программатор, затем делаем вывод о замене флэш..
ЗЫ.
Цитата:
Вот RPL:
где файл бекапа??
__________________
Век живи, век учись..
yurii-62 вне форума   Вверх