|
PDA часть уже пробывал, она восстанавливается на ура, а следом если сразу восстанавливать модем то вот лог. Если запитывать от блока потребление в районе 180 мА.
[07.02.2011 13:18:19] [START OPERATION_ID = RESURRECT]
[07.02.2011 13:19:03] Open serial port...OK
[07.02.2011 13:19:03] Connecting to the RIFF Box...OK
[07.02.2011 13:19:03] Firmware Version: 1.16, JTAG Manager Version: 1.22
[07.02.2011 13:19:03] Selected Resurrector: [Samsung i900 PDA]
[07.02.2011 13:19:03]
[07.02.2011 13:19:03] Connecting to the dead body...OK
[07.02.2011 13:19:03] Detected dead body ID: 0x2E649013 - CORRECT!
[07.02.2011 13:19:03] Set I/O Voltage reads as 3.29V, TCK Frequency is 10 MHz
[07.02.2011 13:19:03]
[07.02.2011 13:19:03] Resurrection sequence started.
[07.02.2011 13:19:03] Establish communication with the phone...OK
[07.02.2011 13:19:03] Initializing internal hardware configuration...OK
[07.02.2011 13:19:03] Uploading resurrector data into memory...OK
[07.02.2011 13:19:03] Starting communication with resurrector...OK
[07.02.2011 13:19:03]
[07.02.2011 13:19:03] Detected an Initialized FLASH1 Chip ID: 0x00EC/0x0040 (256MB)
[07.02.2011 13:19:03] Flashing the dead body...OK
[07.02.2011 13:19:03] Resurrection complete!
[07.02.2011 13:19:03] [FINISH OPERATION_ID = RESURRECT]
[07.02.2011 13:19:26] [START OPERATION_ID = RESURRECT]
[07.02.2011 13:19:34] Open serial port...OK
[07.02.2011 13:19:34] Connecting to the RIFF Box...OK
[07.02.2011 13:19:34] Firmware Version: 1.16, JTAG Manager Version: 1.22
[07.02.2011 13:19:34] Selected Resurrector: [Samsung i900 Modem]
[07.02.2011 13:19:34]
[07.02.2011 13:19:34] Connecting to the dead body...OK
[07.02.2011 13:19:34] Detected dead body ID: 0xA00C00E1 - CORRECT!
[07.02.2011 13:19:34] Set I/O Voltage reads as 2.80V, TCK Frequency is 10 MHz
[07.02.2011 13:19:34]
[07.02.2011 13:19:34] Resurrection sequence started.
[07.02.2011 13:19:34] Establish communication with the phone...OK
[07.02.2011 13:19:34] Uploading resurrector data into memory...FAILED
[07.02.2011 13:19:34] ERROR: Memory access timed out.
[07.02.2011 13:19:34] [FINISH OPERATION_ID = RESURRECT]
[07.02.2011 13:19:47] [START OPERATION_ID = DCC_WRITE_MEMORY]
[07.02.2011 13:19:48] Open serial port...OK
[07.02.2011 13:19:48] Connecting to the RIFF Box...OK
[07.02.2011 13:19:48] Firmware Version: 1.16, JTAG Manager Version: 1.22
[07.02.2011 13:19:48] Selected Resurrector: [Samsung i900 Modem]
[07.02.2011 13:19:48]
[07.02.2011 13:19:48] Connecting to the dead body...OK
[07.02.2011 13:19:48] Detected dead body ID: 0xA00C00E1 - CORRECT!
[07.02.2011 13:19:48] Set I/O Voltage reads as 2.81V, TCK Frequency is 10 MHz
[07.02.2011 13:19:48]
[07.02.2011 13:19:48] Resurrection sequence started.
[07.02.2011 13:19:48] Establish communication with the phone...OK
[07.02.2011 13:19:48] Uploading resurrector data into memory...FAILED
[07.02.2011 13:19:48] ERROR: Memory access timed out.
[07.02.2011 13:19:48] [FINISH OPERATION_ID = DCC_WRITE_MEMORY]
|