|
i900 ERROR: Wrong DCC data checksum.. при восстановлении модема
Все по инструкции, плату чистил хотя и слодов воды и не было, кабеля перепроверил мах 15см, пробывал и с USB шнуром и без него, с внешнего источника и с акб, в собранном виде и только плату, пробывал менять USB шнур к Riff, пробывал на другом ПК. Ничего не изменилось. С частотой ТСК игрался, почему то чем выше частота тем лучше лог, но в результате все то же...
Лог:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.16, JTAG Manager Version: 1.22
Selected Resurrector: [Samsung i900 Modem]
Connecting to the dead body...OK
Detected dead body ID: 0x2E649013 - CORRECT!
Set I/O Voltage reads as 3.29V, TCK Frequency is 10 MHz
Initializing internal hardware configuration...OK
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.16, JTAG Manager Version: 1.22
Selected Resurrector: [Samsung i900 Modem]
Connecting to the dead body...OK
Detected dead body ID: 0xA00C00E1 - CORRECT!
Set I/O Voltage reads as 2.80V, TCK Frequency is 10 MHz
Resurrection sequence started.
Establish communication with the phone...OK
Uploading resurrector data into memory...FAILED
ERROR: Memory access timed out.
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.16, JTAG Manager Version: 1.22
Selected Resurrector: [Samsung i900 Modem]
Connecting to the dead body...OK
Detected dead body ID: 0xA00C00E1 - CORRECT!
Set I/O Voltage reads as 2.81V, TCK Frequency is 10 MHz
Resurrection sequence started.
Establish communication with the phone...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...FAILED
ERROR: Wrong DCC data checksum.
|