[yurii-62]

Сообщение от Vadymus

Тему не стал создавать новую..
Принесли тело на прошивку , постоянный ребут..залил 4.2.2 тел не включается ошибка

Image size too large!! w:1080, h:1920
display image fail
SECURE FAIL: KERNEL

Залил 4.4.2 ТА завёлся но IMEI неизвестный S/N типа 20fe35
Octopus-ом при попытке исправить IMEI постоянно вылетаю ошибки

И причем тут Вoot..
для Вас (Repair IMEI/Serial/BT/WiFi/Product Code)

REPAIR INSTRUCTIONS:

REPAIR INSTRUCTIONS:
Repair IMEI/Serial/BT/WiFi/Product Code:
1. Power on the phone.
2. Type *#0808# and select 'DM+MODEM+ADB'.
3. Reboot phone.
4. Connect USB cable, install drivers if needed.
5. Select Samsung diagnostic port in port settings.
6. Press 'Reset MSL' button to deactivate security.
7. Wait till phone reboot.
8. Tap 7 times on 'Build number' in 'Settings'-'About phone' to enable 'Developer options',
go to 'Settings'-'Developer options' and enable 'USB debugging'.
9. Select device in ADB settings.
10. Fill values what you need to repair.
11. Press 'Repair' button.

Reset EFS, Disable Factory Mode:
Phone must be rooted!
If the software can't root the phone automatically,
then you must root your device manually.
1. Power on the phone.
2. Tap 7 times on 'Build number' in 'Settings'-'About phone' to enable 'Developer options',
go to 'Settings'-'Developer options' and enable 'USB debugging'.
3. Connect the phone to PC with USB cable, install drivers if needed.
4. Select device in ADB settings.
5. Press 'Reset EFS' if you need to reset it.
Be carefully, do not perform this without necessity. Backup will be created automatically.
6. If you have yellow table on your device screen, then press 'Disable Factory Mode' button.

Wipe EFS/NVM:
If you have 'IMEI null/null' or 'Phone baseband unknown' errors,
Then you can try to repair this errors with this function.
Phone must be rooted!
If the software can't root the phone automatically,
then you must root your device manually.
1. Power on the phone.
2. Tap 7 times on 'Build number' in 'Settings'-'About phone' to enable 'Developer options',
go to 'Settings'-'Developer options' and enable 'USB debugging'.
3. To use 'Auto backup/restore QCN' function (recommended):
Type *#0808# and select 'DM+MODEM+ADB'.
Type *#9090# and select 'DM/DUN over HSIC'.
Or you can disable this function and use ADB only.
4. Connect the phone to PC with USB cable, install drivers if needed.
5. Select device in ADB settings.
6. Choose diagnostic port in port settings if 'Auto backup/restore QCN' is not skipped.
7. Press 'Wipe EFS/NVM' button.

Судя по выше изложенному, может всеж в СЦ..