[Tellmypl]

SERVICE socket
10 pin layout
1 - BOX GENIO1
2 - VBAT 5v
3 - BOX GENIO2
4 - BSI
5 - BOX RX_1
6 - BOX TX_1
7 - MBUS
8 - GND
9 - VPP
10 - BOX GENIO3

As you can see, pinout is compatible with UFS/JAF and other common Nokia boxes. For DCT4 you can plug directly UFS/JAF cables without any adapter. With BB5, most 8-pin market cables have TX2 instead VPP Pin. Our box dont have connected data line to VPP - only to power IC.
Tx2 might be changed ON THE FLY to any of GENIO pins in further updated maybe also possible 100 flexible pinout modification, so ALL cables on markets will be supported.
Bundled adapter crossing pin 3 with 9. That means on output from adapter, on pin 8 you will have TX2 service pin 3 and still compatibility with UFS/JAF cables will be. VPP is not cutted. Its on pin nr 3 unused pin nr 2 - jaf/ufs cables so still VPP funcionality can be used on 8 pin cables, instead of purchasing 10 pin With small mods needed, of course.
You can use too native 10pin Cyclone cables, but they are not avaiable on market at moment.


DIAGNOSTIC socket
1 - VBAT 5v
2 - USART CLK
3 - USART TXD
4 - FREQ_MEASURMENT_A0
5 - FREQ_MEASURMENT_CLK
6 - DIAG_1_VOLTMETER
7 - DIAG_2_VOLTMETER
8 - DIAG_3_VOLTMETER
9 - USART RXD
10 - GND